KitchenAid KHMD4 60510 Mode d'emploi télécharger pdf (Page 12)

The minimum flow level is regulated using the tap at the lowest posi-

tion (small flame) .

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the con-

trol knob and adjust the screws on the tap as follows:

1. Tighten to decrease the height of the flame 1 (-)

2. Loosen to increase the height of the flame (+);

3. With the burners on, turn the control knobs from the

maximum to the minimum position to check the stability

of the flame.

To replace the injectors in the special burner:

1. Remove the burner ring (A).

2. Unscrew the injector (B) using a 7 mm hex key.

3. Replace the injectors.

4. Refit the burner ring.

Note: Make sure that:

1. The burner ring (A) is seated correctly on the burner following

replacement.

Regulating the minimum flow level of the gas taps

Replacing the injectors in the wok burner

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

KitchenAid KHMD4 60510 Mode d'emploi Page 12