KitchenAid Dishwasher KD-18 Manuel d'utilisateur télécharger pdf

BUILT-IN

DISHWASHER

KD-

I8 SERIES

INSTALLATION

INSTRUCTIONS

MR. INSTALLER: HAVE YOU CHECKED!

PLACEMENT OF DISHWASHER

0 1. Remove styrofoam packing blocks from top and corrugated motor block packing from rear

of unit after dishwasher is removed from skid.

2. Properly positioned-level, aligned and square with cabinet opening.

0 3. Anchored securely, either to cabinet or floor.

4. Installation debris removed .from under dishwasher.

ELECTRICAL CONNECTION

0 1. Separate 115 volt, 60 hertz, 1 phase branch with a 15 ampere capacity protected by a

maximum of 15 ampere fuse size.

0 2. Dishwasher properly grounded.

0 3. All connections in conformance with local electrical code.

PLUMBING -

0 1. Water supply at dishwasher: 20 to 120 P.S.I. pressure, temperature of 140” F. to 160” F.

and l/2” O.D. (min.) copper tube.

0 2. Drain lines at least 5/8” O.D. copper tubing or equivalent without drain air gap and with no

tight bends (kinks) or other restrictions to prevent complete draining.

0 3. Drain lines at least g/16” l.D.copper tubing or equivalent with drain air gap and with no

tight bends (kinks) or other restrictions to prevent complete draining.

0 4. Compliance with all aspects of local plumbing code.

0 5. Make sure drain hose does not touch any electrical components or terminals.

OPERATIONAL

0 1. All internal packing material and labels and door pads removed.

Place detergent in both compartments of detergent dispenser, close cover(s) and

operate dishwasher through complete “Normal Cycle.” Note: KDC has cover over

only one of two compartments.

Check: Proper Fill-Water level approximately l-1/2” below centerline of 4 Way Hydro

Sweep tubes. Complete Drain.

Detergent Dispenser-must operate automatically and completely dispense

detergent.

Dishracks, for freedom of movement and adjustment.

THANK YOU MR. INSTALLER:

1. Complete Installation Check List.

2. Leave all literature (Incl. Check List) for customer.

3. Notify dealer that electrical work and plumbing are completed.

FOR DEWED INSTRUCTIONS, FOLLOW METHODS DESCRIBED IN THIS FOLDER

1 2 3 4 5 6

Résumé du contenu

Page 1 - INSTRUCTIONS

/ BUILT-IN DISHWASHER KD- I8 SERIES INSTALLATION INSTRUCTIONS MR. INSTALLER: HAVE YOU CHECKED! PLACEMENT OF DISHWASHER 0 1. Remove styrofoam

Page 2 - ALLATION INSTRUCTIONa

IMPORTANT: Read Before Installing to Save Time, Work,-1 ’ assure proper performance, and owner’s warranty protection, KD-IK INSTALLATIO

Page 3 - DRAIN SYSTEM

OPENING FOR DISHWASHER + 24” ---+! STAYING BEHIND VERTICAL FRAME MEMBER f3lHER R.H. OR LH. SIDE. FIG. 3 0 2 HOT WATER SUPPLY LINE If the

Page 4 - FINAL INSTALLATION

0 3 DRAIN SYSTEM (Cont.) --‘- 34’ - u-------y -! I MIX. (57*~01R0) MIX. (57*~01R0) ---00” -00” MAX. IN RESRICIED - - MAX. IN RESRICIED - -

Page 5

0 2 CONNECTING HOT WATER SUPPLY LINE Make certain fill line has been flushed clear of foreign materials. Use compression ell (furnishe

Page 6 - CAUTION

-. I’ DETAILS AND CONNECTIONS CAUTION For in&liation when the dishwasher is to be left unused in freezing temperatures: Turn off e

Commentaires sur ces manuels

Pas de commentaire

KitchenAid Dishwasher KD-18 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Lave-vaisselle KitchenAid Dishwasher KD-18. KitchenAid Dishwasher KD-18 User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle KitchenAid Dishwasher KD-18