Kitchenaid Bottom-Mount Refrigerator Manuel d'utilisateur télécharger pdf (Page 9)

Center Hinge

1. Center Hinge Pin

2. Phillips Screws

3. Center Hinge

Bottom Hinge

1. Bottom Hinge Cover

2. Bottom Hinge

3. Hex Head Hinge Screws

Base Grille

To remove the base grille:

1. Open the refrigerator door.

2. Grasp the grille with both hands.

3. Lift up and tilt the bottom of the grille toward you.

NOTE: Do not remove the Tech Sheet that is fastened

behind the grille.

To replace the base grille:

1. Open the refrigerator door.

2. Place upper clips in openings in the metal panel.

3. Roll the grille down toward the refrigerator until it snaps

into place.

Door Closing and Alignment

Door Closing

Your refrigerator has two front adjustable rollers – one on

the right and one on the left. If your refrigerator seems

unsteady or you want the doors to close easier, adjust the

refrigerator's tilt using the instructions below:

1. Plug refrigerator power cord into a 3-prong grounded

outlet. Move the refrigerator into its final position.

2. Remove the base grille (see “Base Grille” earlier in this

section). The two roller adjustment screws are part of

the front roller assemblies which are at the base of the

refrigerator on either side.

3. Use a screwdriver to adjust the roller adjustment

screws. Turn the roller adjustment screw to the right to

raise that side of the refrigerator or turn the roller

adjustment screw to the left to lower that side. It may

take several turns of the roller adjustment screws to

adjust the tilt of the refrigerator.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the roller adjustment

screws and rollers. This makes it easier to adjust the

screws.

4. Open both doors again and check to make sure that

they close as easily as you like. If not, tilt the

refrigerator slightly more to the rear by turning both

roller adjustment screws to the right. It may take

several more turns, and you should turn both roller

adjustment screws the same amount.

5. Replace the base grille.

Door Alignment

If the space between your doors looks uneven, you can

adjust it using the instructions below:

1. Pry off the top hinge cover.

2. Loosen the top hinge screws using a ⁵⁄₁₆-inch socket or

wrench.

3. Have someone hold the door in place or put a spacer

between the doors while you tighten the top hinge

screws.

4. Replace the top hinge cover.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Kitchenaid Bottom-Mount Refrigerator Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Kitchenaid Bottom-Mount Refrigerator