KitchenAid KRMF706ESS Manuel d'utilisation et d'entretien télécharger pdf (Page 5)

555555

Bottom Door Hinge

For your convenience, the refrigerator doors have bottom hinges

with door closers. These closers allow the doors to swing fully

closed with just a gentle push.

IMPORTANT: So that the closers feature will operate properly, the

doors must be removed only when open to a 90° angle to the front

of the cabinet. If one or both doors were not at a 90° angle when

removed, the bottom door hinge must be reset.

Reset the Door Hinge

1. Lift the door from the bottom hinge pin and place it on a flat

surface.

2. Using a driver with a #2 square bit, remove the bottom hinge

with the bushing from the cabinet.

3. Insert the bottom hinge and bushing into the corresponding

slot in the bottom of the door.

NOTE: Make sure that the base of the hinge is parallel to the

bottom of the door.

4. Turn the hinge until the hinge base is at a 90° angle to the

bottom edge of the door.

5. Remove the hinge from the door. Using a driver with a

#2 square bit, reattach the bottom hinge to the refrigerator

cabinet.

6. The hinge is now reset and prepared for the door to be

replaced. See “Replace Refrigerator Doors” later in this

section.

A. Bushing

B. Hinge base

90˚

A. Hinge base parallel to the bottom edge of the door

A. Hinge base turned to a 90° angle with the

bottom edge of the door

90°

1 2 3 4 5 6 7 8 9 10 ... 119 120

Pas de commentaire

KitchenAid KRMF706ESS Manuel d'utilisation et d'entretien Page 5