KitchenAid KGCU467VSS Manuel d'utilisation et d'entretien télécharger pdf (Page 10)

3. Remove the drip tray.

4. Clean basin. See “General Cleaning” section.

To Replace:

1. Slide drip tray into opening on the right front side of the grill

basin. There are guides to assure correct placement of the

drip tray.

2. Insert the large grease tray all the way under the back edge of

the grill basin and hook it into the slots.

3. Insert the small grease tray all the way under the front of the

grill basin and hook it into the slots.

When the 2 grease trays are installed properly, the small

grease tray will hook over the large grease tray.

4. Insert the orifice tube on the front of the burner assembly into

the opening at the front of the grill basin and set burner

assembly into place.

5. Insert front tabs of the flame spreader into slots at the front of

the grill basin, then the rear tabs into the rear slots.

6. Place the wave tray on top of the flame spreader.

7. Place the grill grate into position.

To Use:

1. Turn on overhead range hood.

2. If desired, apply a light coating of vegetable oil or nonstick

cooking spray to grill grate.

3. Push in and turn knob to LITE/HI. The flame will ignite in

1 to 4 seconds. Turn knob to MED and allow grill to preheat

for 15 minutes.

4. Turn knob to desired cook setting. Place food on grill.

A. Drip tray

A. Large grease tray

B. Slots

A. Large grease tray

B. Grease tray connection

C.Small grease tray

D. Slots

A. Front opening

A. Front tabs and slots

B. Rear tabs and slots

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

KitchenAid KGCU467VSS Manuel d'utilisation et d'entretien Page 10