KitchenAid KXD4636YSS Manuel d'instructions télécharger pdf (Page 11)

Install Vent System

1. Place cardboard or similar material on top of a flat surface

where you can easily assemble the downdraft vent system.

2. Remove parts packages, downdraft vent and blower box

from the carton.

3. Remove all shipping materials, tape and film from the

downdraft vent and blower box.

4. Install the right and left undercounter mounting brackets to

the vent box. Slide the keyhole slots over the guide tabs and

push the brackets up to set them in place.

5. Attach the right and left end caps to the vent box. Place the

tab into the mounting slot at each end of the downdraft vent

as shown and push down to lock into place.

6. Measure distance “X” from the cabinet floor to the top of the

countertop. Subtract 28¹⁄₂" from distance “X” to determine

dimension “Y” (X - 28¹⁄₂ = Y).

7. Attach the support legs to the side of the vent box with

4-4x8mm screws in each support leg. Adjust to dimension

“Y” from the bottom of the vent box to the bottom of the

support legs. Tighten screws.

Determine Which Vent Direction Is Best for Your

Installation

When installed in a cabinet, vent system can exhaust through the

bottom, right or left of the cabinet.

NOTE: When using the 6" (15.2 cm) vent transition (supplied) for

6" round venting, only left or right venting is recommended.

A. Vent box

B. Undercounter mounting bracket

C. Keyhole slots

D. Guide tabs

A. End cap tab

B. Mounting slot

WARNING

Excessive Weight Hazard

Use two or more people to move and install

downdraft vent.

Failure to do so can result in back or other injury.

A. Motor box

B. Support leg

C. 4 x 8 mm screws (4)

Cabinet floor

Top of countertop

Downdraft vent

“X”

“Y”

28¹⁄₂"

(73 cm)

Dim. “Y”

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

KitchenAid KXD4636YSS Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers KitchenAid KXD4636YSS