KitchenAid KXD4636YSS Manuel d'instructions télécharger pdf (Page 13)

5. Remove the screws from the wire mounting plate.

6. Hold the wire mounting plate and push the grommet out of

the mounting plate.

7. Slide the wire assembly through the slot in the wire mounting

plate to remove it.

8. Place the wire assembly through the opening to the opposite

side of the vent box.

9. Reassemble the wire assembly and grommet to the wire

mounting plate

10. Install the wire mounting plate to the vent box using the 4

screws previously removed.

11. Place the blower motor box assembly with the keyhole slots

over the 2 shoulder screws on the rear of the vent box and

reconnect the wire connection to the blower motor.

12. Mount the blower motor box to the vent box and secure using

the 6 screws previously removed.

13. Mount the 4³⁄₄" (12.0 cm) cover box (supplied) to the front of

the vent box. Place the keyhole slots over the 2 shoulder

screws, align the mounting holes, and secure the cover box

to vent box using the 6 screws previously removed from the

¹⁄₄" (6.4 mm) deep cover.

14. Go to the “Complete Installation (Interior-Mounted Motor)”

section.

Complete Installation

(Interior-Mounted Motor)

NOTE: The downdraft vent system is supplied with a 3¹⁄₄" x 10"

(8.3 x 25.4 cm) back draft damper and a 6" (15.2 cm) round vent

transition with damper. Refer to “3¹⁄₄" x 10" (8.3 x 25.4 cm) back

draft damper” or “6" (15.2 cm) round vent transition with

damper,” depending upon the type of venting you are using.

3¹⁄₄" x 10" (8.3 x 25.4 cm) Back Draft Damper

1. Attach the 3¼" x 10" (8.3 x 25.4 cm) back draft damper to the

vent opening in the blower motor box, using three 3.5 x

9.5 mm screws.

6" (15.2 cm) Round Vent Transition with Damper

1. Attach the 6" (15.2 cm) round vent transition to vent opening

(left or right side venting only is recommended), using two

3.5 x 9.5 mm screws.

A. Screws

B. Wire mounting plate

C. Blower motor box

A. Wire mounting plate

B. Grommet

A. 3.5 x 9.5 mm screws

B. 3¼" x 10" (8.3 x 25.4 cm)

back draft damper

A. 3.5 x 9.5 mm screws

B. 6" (15.2 cm) round vent transition with damper

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

KitchenAid KXD4636YSS Manuel d'instructions Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers KitchenAid KXD4636YSS